![Ethereal - AS-SS6](https://cdn-images.av-iq.com/products/enlarge/AS-SS6.jpg)
![Ethereal - AS-SS6](https://cdn-images.av-iq.com/products/enlarge/AS-SS6.jpg)
![Ethereal - AS-SS6](https://cdn-images.av-iq.com/products/gallery/small/AS-SS6_2.jpg)
![Ethereal - AS-SS6](https://cdn-images.av-iq.com/products/gallery/small/AS-SS6_1.jpg)
![Ethereal - AS-SS6](https://cdn-images.av-iq.com/products/gallery/small/AS-SS6_3.jpg)
6 Zone Speaker Selector
Model: AS-SS6
- Route speaker cables from each listening zone to the speaker selector
- Route speaker cables from the amplifier to the speaker selector
- Remove approximately 8 inches of the outer jacket from the speaker cable (if necessary)
- Strip approximately 3/8 inches of insulation from each conductor and twist the exposed strands together to avoid fraying
- Press the push terminal and insert the conductor; release to make contact
Distribute a stereo speaker-level signal to multiple listening zones with the Helios AS-SS6. This Low Profile 6 Zone Speaker Selector features a manually activated impedance protection circuit, accommodations for 14 gauge cable, and in-wall installation options. To prevent impedance to the amplifier from dropping below 5 Ohms, simply switch the protection function ON. It can also be turned OFF when used as part of a system incorporating impedance matching volume controls. The terminals at the rear of the speaker selector will accommodate up to 14 gauge cable; sufficient for cable runs exceeding 100 feet. For shorter distances 16-18 gauge cable suffices. CL-2 or CL-3 rated cable is recommended for compliance with local building codes. When connecting a speaker and amplifier, maintain polarity: positive to positive and negative to negative.
- Route speaker cables from each listening zone to the speaker selector
- Route speaker cables from the amplifier to the speaker selector
- Remove approximately 8 inches of the outer jacket from the speaker cable (if necessary)
- Strip approximately 3/8 inches of insulation from each conductor and twist the exposed strands together to avoid fraying
- Press the push terminal and insert the conductor; release to make contact
- Set Impedance Protection to ON and OFF as necessary
- Warranty - Yes
- Spec Sheet available - Yes
- Warranty (Length/Type): Limited 1 Year
![Company logo](https://cdn-images.av-iq.com/company/308205medium.gif)
AudioTec Designs, Inc.
4601 N Dixie Highway
Boca Raton, FL 33431
USA
(561) 368-4411
https://www.audiotecdesigns.com/